Engineering, 07.04.2020 21:50 lashaaungas

Which shows the correct substitution of the values a, b, and c from the equation –2 = –x + x2 – 4 into the quadratic formula? Quadratic formula: x = StartFraction negative b plus or minus StartRoot b squared minus 4 a c EndRoot Over 2 a EndFraction x = StartFraction negative (negative 1) plus or minus StartRoot (negative 1) squared minus 4 (1)(negative 4) EndRoot Over 2(1) EndFraction x = StartFraction negative 1 plus or minus StartRoot 1 squared minus 4 (negative 1)(negative 4) EndRoot Over 2(negative 1) EndFraction x = StartFraction negative (negative 1) plus or minus StartRoot (negative 1) squared minus 4 (1)(negative 4) EndRoot Over 2(1) EndFraction x = StartFraction negative (negative 1) plus or minus StartRoot (negative 1) squared minus 4 (1)(negative 2) EndRoot Over 2(1) EndFraction

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

You know the right answer?

Which shows the correct substitution of the values a, b, and c from the equation –2 = –x + x2 – 4 in...

Questions