subject
Engineering, 07.04.2020 16:20 tinaxiao

You are given the 500-mb heights and absolute vorticity maps at 12Z on December 31. You are also given near-surface temperatures (40 meters above the ground) for the same time.

12Z 12/31 500-mb Heights
12Z 12/31 500-mb Abs. Vorticity
12Z 12/31 40m Temperature

At the time the seed of the snowstorm started to sprout, there was a potent short-wave trough at 500 mb associated with a powerful surface low-pressure system that was moving away from the coast of Maine. There was also a short-wave trough at 500 mb over the upper Middle West associated with an "Alberta Clipper", which is a modest surface low-pressure system that usually brings only a nuisance snow along and north of its path. The reason I mention these two systems is that I want to point you away from them. Just so you won't get confused -- neither one of these systemsserved as the catalyst for triggering the low-pressure system that ultimately dumped heavy snow in eastern Pennsylvania. In other words, ignore these two short-wave troughs!

At this time a weak surface low has just formed. Complete the following statement: The newly formed surface low is located at approximately N W (latitude/longitude... ex. "36N 70W") and (relative location... ex. "east/west", "upstream/downstream", etc ) of the 500-mb short wave trough axis. Note: A range of values will of course be accepted for the longitude/latitude estimate of the surface low's position.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
You know the right answer?
You are given the 500-mb heights and absolute vorticity maps at 12Z on December 31. You are also giv...
Questions
question
Mathematics, 31.08.2019 23:10
question
Mathematics, 31.08.2019 23:10
question
Computers and Technology, 31.08.2019 23:10