Engineering, 07.04.2020 04:43 cheerthi16
In a turning operation on stainless steel with hardness = 200 HB, the cutting speed = 200 m/min, feed = 0.25 mm/rev, and depth of cut = 3.5 mm. How much power will the lathe draw in performing this operation if its mechanical efficiency = 90%?
Answers: 3
mm
mm
W
W
kW
Another question on Engineering
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
In a turning operation on stainless steel with hardness = 200 HB, the cutting speed = 200 m/min, fee...
Questions
Physics, 13.07.2021 18:10
Mathematics, 13.07.2021 18:10
Mathematics, 13.07.2021 18:10
History, 13.07.2021 18:10
Medicine, 13.07.2021 18:10
Medicine, 13.07.2021 18:20
History, 13.07.2021 18:20
Computers and Technology, 13.07.2021 18:20
Mathematics, 13.07.2021 18:20
Mathematics, 13.07.2021 18:20
Social Studies, 13.07.2021 18:20
Mathematics, 13.07.2021 18:20
