Engineering, 04.04.2020 06:02 crtlq
Twenty-four voice signals are sampled uniformly and then time-division multiplexed. The sampling operation uses flat-top samples (Natural Sampling) with 1 μs duration. The multiplexing operation includes provision for synchronization by adding an extra pulse of sufficient amplitude and also 1 μs duration. The highest frequency component of each voice signal is 3.4 kHz.
a) Assuming a sampling rate of 8 kHz, calculate the spacing between successive pulses of the multiplexed signal.
b) Repeat your calculation assuming the use of Nyquist rate sampling.
c) Sketch the timing and synchronization signals needed at the receiver to correctly recover the pulses for each of the twenty-four sources.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 19:20
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
You know the right answer?
Twenty-four voice signals are sampled uniformly and then time-division multiplexed. The sampling ope...
Questions
History, 18.01.2020 03:31
Geography, 18.01.2020 03:31
Chemistry, 18.01.2020 03:31
Mathematics, 18.01.2020 03:31
Chemistry, 18.01.2020 03:31
