Engineering, 04.04.2020 02:02 885122bah
G Calculate the following for the shaft and the hole given below (dimensions in inches): (a) Tolerance on the shaft (b) Tolerance on the hole (c) Allowance (minimum clearance) (d) Maximum clearance (e) Type of fit
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
You know the right answer?
G Calculate the following for the shaft and the hole given below (dimensions in inches): (a) Toleran...
Questions
Chemistry, 22.12.2020 19:20
Chemistry, 22.12.2020 19:20
English, 22.12.2020 19:20
Biology, 22.12.2020 19:20
Mathematics, 22.12.2020 19:20
Spanish, 22.12.2020 19:20
English, 22.12.2020 19:20
Mathematics, 22.12.2020 19:20
English, 22.12.2020 19:20
English, 22.12.2020 19:20
Spanish, 22.12.2020 19:20
Mathematics, 22.12.2020 19:20
English, 22.12.2020 19:20
