Engineering, 03.04.2020 23:48 ashleyuchiha123

If the number of teeth in the gears 1 and 2 are 60 and 40, the module pitch =3 mm, the pressure angle 20o and the addendum = 0.318 of circular pitch determine the velocity of sliding when the contact is at the tip of the tooth of gear 2 and the gear 2 rotates at 800 rpm

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is a monomer? how do they form a ploymer from the view point of chemical bonding?

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

You know the right answer?

If the number of teeth in the gears 1 and 2 are 60 and 40, the module pitch =3 mm, the pressure angl...

Questions