Engineering, 30.03.2020 21:22 amaraea

The volume of an injection-molded part is 15.2 cm3. The volume of the sprue and runner is 8.5 cm3. The starting plastic is polypropylene; its specific gravity is listed in Table 8.1. The price of the plastic = $1.98/kg. A two-plate mold with one cavity is used. Determine the material price per piece if the sprue and runner (a) can be ground and mixed with the starting plastic so that material utilization is 100% and (b) cannot be reground because virgin plastic must be used.

Solve the previous problem, except that the two-plate mold has two cavities instead of one. The volume of the sprue and runner is increased to 9.6 cm3 to accommodate two mold cavities. Determine the material price per piece if the sprue and runner (c) can be ground and mixed with the starting plastic so that material utilization is 100% and (d) cannot be reground because virgin plastic must be used. (e) How would the use of a three-plate mold affect the answers in (c) and (d)? (f) How would the use of a hot-runner mold affect the answers in (c) and (d)?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

You know the right answer?

The volume of an injection-molded part is 15.2 cm3. The volume of the sprue and runner is 8.5 cm3. T...

Questions