subject
Engineering, 30.03.2020 21:00 sswaqqin

Design a full-wave bridge rectifier to supply 12V DC voltage to a resistive load of RL=3Ω at the output, assuming an AC supply with 60 Hz frequency with the following characteristics: a) Unfiltered (without output capacitor) b) Filtered. Design a filter capacitor so that the ripple factor of the output voltage is less than %5. Regularly if you add a filter capacitor, the average output voltage would increase. You should revise the AC supply peak voltage VVmm calculated in (a) to match the average 12V DC requirement. Find and report the final value of VV�

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Design a full-wave bridge rectifier to supply 12V DC voltage to a resistive load of RL=3Ω at the out...
Questions
question
English, 14.10.2019 16:30
question
Business, 14.10.2019 16:30