Engineering, 27.03.2020 02:55 hardwick744

Hot engine oil with heat capacity rate of 4440 W/K (product of mass flow rate and specific heat) and an inlet temperature of 150ºC flows through a double pipe heat exchanger. The double pipe heat exchanger is constructed using a 1.5-m-long copper pipe (k = 250 W/m. K) with an inner tube of inside diameter 2 cm and outside tube diameter of 2.25 cm. The inner diameter of the outer tube of the double pipe heat exchanger is 6 cm. Oil flowing at a rate of 2 kg/s through inner tube exits the heat exchanger at a temperature of 50ºC. The cold fluid, i. e., water enters the heat exchanger at 20ºC and exits at 108ºC. Assume the fouling factor on the oil side and water side to be 0.00015 m2.K/W and 0.0001 m2.K/W, respectively.

The properties of water evaluated at an average temperature at the average inlet and exit temperatures of 20ºC and 70ºC or 45ºC are

rho = 990.1kg/m^3
Cp= 4180J/kg. K
k= 0.637W/m. K
μ= 0. 596 ×10^-3 kg/m. s
Pr = 3.91

Calculate the mass flow rate of water.(Round the answer to three decimal places.)

Answers: 2

Show answers

Another question on Engineering

Engineering, 06.07.2019 03:30

Acubic shaped box has a side length of 1.0 ft and a mass of 10 lbm is sliding on a frictionless horizontal surface towards a 30 upward incline. the horizontal velocity of the box is 20 ft/s. determine how far up the incline the box will travel (report center of mass distance along the inclined surface, not vertical distance)

Answers: 1

Answer

Engineering, 06.07.2019 04:20

What is the fuid acceleration in vector form for the following velocity field? note i, j, and k are unit vectors. show all of your work.

Answers: 1

Answer

Engineering, 06.07.2019 05:20

An ideal rankine cycle with reheat uses water as the working fluid. the conditions at the inlet to the high pressure turbine are 10mpa, 650°c and the steam is reheated at a constant pressure of 1.4mpa before entering the low pressure turbine. for a condenser pressure of 10kpa, plot the cycle thermal efficiency and quality of steam at the low pressure turbine exit versus reheat temperatures (the temp of steam entering the low pressure turbine) of 400, 500, and 600°c. draw the t-s diagram and show all your work for a reheat temperature of 400°c .note, there will be two plots. one with thermal efficiency on in the ordinate versus reheat temperate and the other will have quality on the ordinate versus reheat temperature. be sure to label all axes with variables and units and include title. the plots must be done on computer.

Answers: 2

Answer

Engineering, 06.07.2019 05:20

Adrawing operation is to be performed on a perfectly plastic material with strength coefficient- 100 mpa and strain hardening exponent-0. neglect redundant strain. die/work material friction coefficient=0 a)-what is the drawing stress? if this stress is a function of the area reduction, state so. b)-what is the strength of the material after drawing? if this strength is a function of the area 4. reduction, state so. c)-what is the maximum area reduction possible?

Answers: 3

Answer

You know the right answer?

Hot engine oil with heat capacity rate of 4440 W/K (product of mass flow rate and specific heat) and...

Questions