Engineering, 27.03.2020 00:03 autumnxng3094

G Problem 3 (Call by Value). The goal of this problem is to identify the redexes, if any, that can be reduced first in call by value evaluation stratgey for the given expressions. To identify a redex, you should highlight the ( x. t ) part of the redex in yellow and the t’ part of the redex in blue. Here is an example: Example. ( x. x x ) ( x. x x ) ( x. x x ) ( x. x x ) Answer. ( x. x x ) ( x. x x ) ( x. x x ) ( x. x x ) Note that you are only asked to identify the redexes and you are not asked to do the reduction. You are only asked to identify the redex and you are not asked to do the reduction. 1. ( x. x x ) x. x x 2. ( x. ( x. x ) x ) x 3. ( ( x. ( x. x ) x ) x. ( x. x ) x ) ( ( x. x ) x ) 4. ( ( x. ( x. x ) x ) x ( x. x ) x ) ( ( x. x ) x ) 5. x ( x. x ( x. x ) x ) (x. x ( x. x ) x ) x 6. x. x. x x. ( (x. x ) x ) x 7. ( ( x. y. ( y. x ) x. x x ) ) ( ( x. ( y. x ) ) x. x x ) 8. ( x. ( x. ( x. x ) x ) x ) ( ( x. x ) ( x. x ) ( x. x ) ) 9. x ( x. ( y. x ) x. x x ) ( x. ( y. x ) x. x x ) ( ( x. ( y. x ) ) x. x x ) 10. ( x. ( y. x ) x. x x ) ( ( x. ( y. x ) ) x. x x )

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

Answer

Engineering, 06.07.2019 02:30

Precipitation hardening can be achieved in many light alloys by a three-step heat treatment. what is carried out and what is the purpose at each step? why is such a treatment necessary based on the nucleation and growth theory of phase transformation. compare this treatment with tempering martensite for carbon steels (similarities and differences).

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Natural gas (95 percent methane and 5 percent ethane by volume) flows through a 90 cm diameter pipeline with a velocity of 3 m/s. the pressure in the pipeline is 700 kpa, and the temperature is 15°c. calculate: (a) the mass and volumetric flow rates in this pipe.

Answers: 1

Answer

You know the right answer?

G Problem 3 (Call by Value). The goal of this problem is to identify the redexes, if any, that can b...

Questions