Engineering, 20.03.2020 21:02 tk1264

Ride Frequencies and Spring Rates

Problem 1: A monotube damper has a gas charge pressure of 400psig (2.758MPa) (Note: lpsi-6.895kPa). If the damper has a bore diameter of 40mm and a rod diameter of 10mm what would be the maximum compression damping force that could be safely expected of the damper? Assume the chamber above the piston would not want to get under Opsig.

Problem 2: The vehicle in Problem 3&4 of Homework 2 requires a rear coil spring design and is decided it needs a total travel of 5 inches at the wheel hub to safely traverse the road conditions it is expected to see. Using the 1.67:1 mechanical advantage design a coil spring that can fit within a design space that provides a maximum of 12cm diameter for clearance of the spring outside diameter. Using ¾ coil nest open-end construction what is free length and the-installed length at static load? Show your work. (Note: 4.448N-1lbf; 2.54cm-linch)

Problem 3: If the targeted critical damping ratio for the above suspension is determined to be 0.30, what is the target damping rate for the shock absorber that will be mounted coaxially with the spring?

Bonus Points(10): For Problem 1 - If more force is needed in compression damping what options could be used? Are there any compromises with the options?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

You know the right answer?

Ride Frequencies and Spring Rates

Problem 1: A monotube damper has a gas charge pressur...

Questions