Engineering, 20.03.2020 17:05 genyjoannerubiera

A stainless steel plate 1.6cm thick rests on top of a hot plate, which is maintained at 250 degrees C. AIr flows over the top surface of the plate to provide a convective heat-transfer coefficient of h=50 W/m2 *K. The air temperature is maintained at 20 degrees C.

a) What is the heat flux through the stainless steel plate in W/m2 ?

b) What is the temperature at the top surface, T1 , of the stainless steel plate?

c) based on the analysis above, what can you conclude about the heat-transfer resistance offered by the hydrodynamic boundary layer?

Answers: 3

Show answers

Another question on Engineering

Engineering, 06.07.2019 03:10

Different between boring and turning?

Answers: 1

Answer

Engineering, 06.07.2019 03:30

An ammonia compressor has a 5% clearance volume and displacement rate of 80 l/s and pumps against a condensing temperature of 40°c. for two different temperatures of -10°c and 10°c, compute the mass flow rate of refrigerant assuming the clearance volumetric efficiency applies. discharge specific volume corresponding to-10°c and 10°c are 112.5 l/kg and 95 l/kg, respectively.

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Areheat rankine cycle operates with water as the working fluid. steam enters the first turbine at 8 mpa and 450°c and exits at 0.8 mpa. it is then reheated to 400°c before entering the second turbine, where it exits at 10 kpa. if the amount of work into the pump is 8.04 kj/kg and the net work per cycle produced is 1410.25 kj/kg, determine the thermal efficiency of the cycle.

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Agas mixture with a compostion of 55 methane, 30% propane, and 15 butane by volume) is compressed from 1 bar and 25°c to 9bar in a compressor with an isentropic efficiency of 85%. the environment has a temperature of to25 c. determine (a) the exit temperature of the mixture (b) the specific work required to run the compressor (c) the specific entropy generation of the process (d) the specific exergy destruction of the process (e) the second law efficiency of the compressor

Answers: 3

Answer

You know the right answer?

A stainless steel plate 1.6cm thick rests on top of a hot plate, which is maintained at 250 degrees...

Questions