subject
Engineering, 19.03.2020 05:23 mheiser8768

(a) Explain why a stainless steel containing 18wt % Cr is magnetic and is often used for knife blades, while a stainless steel containing 18 wt % Cr and 8 wt% Ni is not magnetic and is often used for stainless steel parts that need to be forged. (Pure Ni has an f. c.c. structure.)(b)Mo, W, and V all readily form small stable carbides. Explain why these elements can be used to produce tool steels thatretain their hardness at temperatures well above the temperature at which martensite would become over-tempered.(c)* A teaspoon is made of a single piece of stainless steel containing nickel. It is observed that the bowl of the spoon is not magnetic, but the handle is. Assume that all parts of the spoon are always at the same temperature, and that plastic deformation is used to form both the bowl and the handle. Explain the difference in properties(why is the crystal structure different).

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k
Answers: 3
question
Engineering, 06.07.2019 03:10
Consider two concentric spheres forming an enclosure with diameters of 12 cm and 18 cm the spheres are maintained at uniform temperatures ti-50°c and t2 = 250°c and have emissivities .45 and .8, respectively. determine the net rate of radiation heat transfer between the two spheres per unit surface area.
Answers: 1
question
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
question
Engineering, 06.07.2019 06:10
Aspeed reducer has 20 full-depth teeth and consists of a 20-tooth steel spur pinion driving a 50-tooth cast-iron gear. the horsepower transmitted is 12 at a pinion speed of 1200 rev/min for a diametral pitch of 8 teeth/in and a face width of 1.5 in, find the contact stress
Answers: 3
You know the right answer?
(a) Explain why a stainless steel containing 18wt % Cr is magnetic and is often used for knife blade...
Questions
question
History, 01.06.2021 14:30
question
Social Studies, 01.06.2021 14:30