subject
Engineering, 17.03.2020 02:05 glass60

Which of the following about ordinal data is TRUE? An ordinal scale implies order but not identity. The attribute being measured must possess the ordinal property to allow ordinal scaling that is meaningful. With an ordinal scale we can say the difference between the first and second is the same as the difference between the second and the third. The calculation of means is appropriate with ordinal data. Grade point average is a good example of an ordinal scale.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
Which of the following about ordinal data is TRUE? An ordinal scale implies order but not identity....
Questions