Engineering, 15.03.2020 00:58 weridness80

A function generator provides digital signalsof different frequencies. To simplify the problem, we assume that this generator allows the user to select one oftworectangular periodic signals. This selection is based on 2 pins:
•If pin 1=High, the output is a rectangular signal ofa frequency of 1KHz
•If pin 2= High, the output is a rectangular signal of a frequency of 10KHz
•If pin 1 and pin2are both Low or High then no signal is generated
To simplify the problem, we assume that all these signals have a duty cycle of 50%.
a)Suggest a block diagram of this function generator
b)Suggest a flowchart of the algorithm
c)Translate the algorithm to a C Arduino code

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

A function generator provides digital signalsof different frequencies. To simplify the problem, we a...

Questions