subject
Engineering, 13.03.2020 05:20 blancasimon239

In a production facility, 3 cm thick large brass plates (k = 110 W/mC, α = 33.9 × 10-6 m2 /s) that are initially at a uniform temperature Ti = 25C are heated by passing through an oven maintained at 700C. The plates remain in the oven for a period of 10 minutes. The average heat transfer coefficient in the oven h = 80 W/m2 C. Determine the surface temperature (C) of the plates when they come out of the oven

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
You know the right answer?
In a production facility, 3 cm thick large brass plates (k = 110 W/mC, α = 33.9 × 10-6 m2 /s) that...
Questions