Engineering, 12.03.2020 18:50 YamiletRdz721

Concrete is required for an exterior column located above ground where substantial freezing and thawing is not a concern. The 28-day compressive strength should be 4,000 lb/in^2. The column dimensions are 12" by 12" with rebar spaced with 2" clear spacing and 1.5" cover (rebar to form).The properties of the materials are as follows:Cement : Type I, specific gravity = 3.15Coarse Aggregate: Bulk specific gravity (SSD) = 2.80;
absorption capacity = 2%;
dry-rodded unit weight = 115 lb/ft^3;
moisture content = 1%Maximum coarse aggregate size availability: 1/2in, 3/4in, 1in or 1.5inFine Aggregate: Bulk specific gravity (SSD) = 2.7;
absorption capacity = 1.3%;
moisture content = 3.7%;
fineness modulus = 2.80Use Slump 1 to 2 inches, and no air entraining1. Calculate the initial weights of water, cement, dry rodded coarse aggregate,(SSD) coarse aggregate, (SSD) fine aggregate, and volume of air per yd^3 of concrete.
2. Calculate the final weights (after moisture adjustments) of cement, coarse aggregate (stockpile), fine aggregate (stockpile), and water to be added to the batch per yd^3 of concrete. Include units.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

Concrete is required for an exterior column located above ground where substantial freezing and thaw...

Questions