Engineering, 12.03.2020 04:58 williamschris462

An inductor of =6.95 H with negligible resistance is placed in series with a ℰ=12.5 V battery, a =3.00 Ω resistor, and a switch. The switch is closed at time =0 seconds. A square loop circuit containing a battery with E M F script E, an open switch S, and inductor of inductance L, and a resistor of resistance R, all connected in series. Calculate the initial current at =0 seconds. (=0 s)= 0 A Calculate the current as time approaches infinity. max= _ A Calculate the current at a time of 1.85 s. (=1.85 s)= _A Determine how long it takes for the current to reach half of its maximum. = ___s

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

An inductor of =6.95 H with negligible resistance is placed in series with a ℰ=12.5 V battery, a =3....

Questions