Engineering, 10.03.2020 00:53 needhelpasap4900

The "impact of jets" testing apparatus is used to measure the force produced by the jet impinging on the reaction vane. It consists of a water supply pipe surrounded by a transparent plastic shield fitted with a top assembly and flat plate reaction (turning) vane. In operation, water from the hydraulic bench is fed into the unit and a vertical water jet is produced and deflected by the reaction vane. The vane is supported by a pivoted beam, restrained by a spring. Adjusting the jockey weight sets the beam to a balanced position. Figure: Schematic of impact of a water jet apparatus (left) and vertical jet of fluid striking a symmetrical vane (right) The impact force by the jet can be also calculated based on the linear momentum change of the jet: Fjet = ņu, (1 – cosB) (1) where ṁ : mass flow rate, uo: velocity that strikes the vane, B:deflected angle of the jet The weight beam was initially at balance with the jockey weight at the zero position. You started the hydraulic bench and increased the mass flow rate to be 0.15 kg/s. You moved the jockey weight until the beam balanced again and the distance y from the zero position, y was 10 mm. 0.00007854m2 3.5 cm Nozzle Area Distance between the nozzle and the impact vane, s Density of water Gravitational acceleration Jockey weight 1000 kg/m3 9.8 m/s2 600 g

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

You know the right answer?

The "impact of jets" testing apparatus is used to measure the force produced by the jet impinging on...

Questions