Engineering, 07.03.2020 05:22 beccca16
The air-handling system for a large indoor sky diving (vertical) wind tunnel has a fan at the inlet (bottom), and a test section (where the users fly) with a circular crosssection of 5.5 m diameter. The designers want to achieve a 200 km/hr wind speed, with the air in the test-section nominally at 22 ºC and 1.0 bar. How much air (mass flow rate) will the fan that runs the wind tunnel have to supply to meet these conditions? If the pressure of the air at the exit of the wind tunnel is 0.2 psi lower than the pressure in the test section, what would be the air velocity at the exit, assuming the air temperature remained at 22 ºC?
Answers: 2
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
Engineering, 04.07.2019 18:20
Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg
Answers: 2
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
The air-handling system for a large indoor sky diving (vertical) wind tunnel has a fan at the inlet...
Advanced Placement (AP), 21.10.2021 14:00
Computers and Technology, 21.10.2021 14:00
Mathematics, 21.10.2021 14:00
Business, 21.10.2021 14:00
Social Studies, 21.10.2021 14:00
Mathematics, 21.10.2021 14:00
Chemistry, 21.10.2021 14:00
English, 21.10.2021 14:00
Social Studies, 21.10.2021 14:00
English, 21.10.2021 14:00
Mathematics, 21.10.2021 14:00
Mathematics, 21.10.2021 14:00