Engineering, 07.03.2020 00:14 macycj8

Two components in cryogenic equipment are held together by stainless steel (ASTM A437 B4B) bolts with diameter of 25 mm. The bolts have a thermal conductivity of 23.9 W/m. K, a specific heat of 460 J/kg .K, and a density of 7.8 g/cm". When the cryogenic fluid flows between the two components, the bolts are submerged in the cold fluid. The length of each bolt submerged in the cryogenic fluid is 5 cm, and the initial temperature of the bolts is 10°C. The cryogenic fluid has a temperature of -40°C with a convection heat transfer coefficient of 40 W/m².K. The ASME Code for Process Piping limits the minimum suitable temperature for ASTM A437 B4B bolts to -30°C (ASME B31.3-2014, Table A-2M). If the bolts are exposed to the cold fluid for 12 min, will they still comply with the ASME code? How long will it take for the bolts to reach the minimum suitable temperature?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

Two components in cryogenic equipment are held together by stainless steel (ASTM A437 B4B) bolts wit...

Questions