Engineering, 06.03.2020 21:31 zaratayyibah

A sequential circuit has one D flip-flop and one JK flip-flop, two inputs x and y, and one output z. A and B are the outputs of each D flip-flop, and JK-flip-flop, respectively. The flip-flop input equations and the circuit output are as follows. Here D_A is the D input of the D-flip flop of A, and J_B, K_B is the J and K input of the JK-flip flop of B. D_A = ~xy + yB J_B = ~yB + xy K_B = xB + ~yA z = x + ~xy Draw the logic diagram of the circuit and test it with Logisim. Please attach the circuit image and the generated table! Please also Submit the circuit file! Construct a state diagram of this circuit.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 05.07.2019 04:30

Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?

Answers: 2

Answer

You know the right answer?

A sequential circuit has one D flip-flop and one JK flip-flop, two inputs x and y, and one output z....

Questions