Engineering, 04.03.2020 04:53 anahitrejo1

To accomplish the design project's Outback Challenge mission, your third design topic to research is a Flight Controller (i. e. manual RC transmitter) and GPS Module. The Flight Controller is not an autopilot, but rather a manual handheld flight control transmitter. If the autonomous operations fail, the Ground Base Control will take control of the UAS to manually release the rescue package (water bottle) to Outback Joe. Using the criteria found in the Outback Challenge, research and select the type of flight controller (i. e. manual handheld RC transmitter) and GPS module you feel would best accomplish the two-fold mission of searching for and delivering a rescue package to Outback Joe.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

You know the right answer?

To accomplish the design project's Outback Challenge mission, your third design topic to research is...

Questions