Engineering, 03.03.2020 18:02 thechameleonnaire

An engineer working in an electronics lab connects a parallel-plate capacitor to a battery, so that the potential difference between the plates is 240 V. Assume a plate separation of d 1.77 cm and a plate area of A-25.0 cm. when the battery is removed, the capacitor is plunged into a container of distilled water. Assume distilled water is an insulator with a dielectric constant of 80.0

(a) Calculate the charge on the plates (in pC) before and after the capacitor is submerged. (Enter the magnitudes.) before pC after Q pC
(b) Determine the capacitance (in F) and potential difference (in V) after immersion.
(c) Determine the change in energy (in nJ) of the capacitor nJ
(d) What If? Repeat parts (a) through (c) of the problem in the case that the capacitor is immersed in distilled water while still connected to the 240 V potential difference Calculate the charge on the plates (in pC) before and after the capacitor is submerged. (Enter the magnitudes.) before Q, - after Q Determine the capacitance (in F) and potential difference (in V) after immersion. pC pC Determine the change in energy (in nJ) of the capacitor. nJ

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

You know the right answer?

An engineer working in an electronics lab connects a parallel-plate capacitor to a battery, so that...

Questions