subject
Engineering, 03.03.2020 05:54 harding6698

In a tensile test on a steel specimen, true strain = 0.12 at a stress of 250 MPa. When true stress = 350 MPa, true strain = 0.26. Determine the strength coefficient and the strain-hardening exponent in the flow curve equation.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
You know the right answer?
In a tensile test on a steel specimen, true strain = 0.12 at a stress of 250 MPa. When true stress =...
Questions
question
Mathematics, 10.09.2021 09:50
question
Mathematics, 10.09.2021 09:50
question
Mathematics, 10.09.2021 09:50
question
Mathematics, 10.09.2021 09:50
question
Geography, 10.09.2021 09:50