Engineering, 03.03.2020 00:33 shinyelish6

A 4MGD groundwater treatment plant receives its source water at temperature and pH of 20oC and 6.5 respectively, a 82mg/L CO2 concentration and a 6.2mg/L Fe2+concentration. An induced draft aerator with 90% efficiency for CO2removal and the capability to achieve equilibrium concentration of dissolved oxygen in water will be used as the initial unit process in the treatment plant.

a. Using Henry's Law, determine the equilibrium concentration of oxygen in mg/L Henry's constant at 20°C is 41,619 atm, and the partial pressure of oxygen is 0.21 atm.
b. Considering equilibrium concentration of dissolved oxygen from (a), will the aerator provide adequate oxygen to oxidize Fe2+ to meet EPA's secondary MCL?
c. For a 20 minute contact time criteria for iron removal, will alkaline chemical addition to adjust pH be necessary?
d. esign a contact tank to achieve optimum Fe2+ oxidation, along with a baffle wall. Show all calculations and clearly provide all assumptions you make for the design criteria.
e. Present your contact tank design through a schematic diagram showing the longitudinal section of the tank with dimensions. Also, present a preliminary layout of the baffle wall with estimated number of orifices. The design drawing does not have to be to scale.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

You know the right answer?

A 4MGD groundwater treatment plant receives its source water at temperature and pH of 20oC and 6.5 r...

Questions