Engineering, 27.02.2020 17:55 razuahammad1603

What are some ways in which power machinery is used in agricultural industry

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Ahousehold refrigerator operating steadily and with a coefficient of performance of 2.5 removes energy from a refrigerated space at a rate of 650 kj/h. evaluating electricity at $0.06 per kw.h, determine the cost of electricity in a month when the refrigerator operates for 360 hours.

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Ir at sea level and 30°c and 50% relative humidity flows at a rate of 1 kg/s through a cooling coil that has an apparatus dewpoint of 10°c. the air leaves the coil at 15°c. determine the following: 3.1)- relative humidity of the air leaving the coil; 3.2)- moisture content of the air leaving the coil; 3.3)- sensible heat factor; 3.4)- total heat transfer rate; 3.5)- sensible heat transfer rate 3.6)- latent heat transfer rate

Answers: 1

Answer

Engineering, 06.07.2019 05:20

Amass of 3 kg of saturated liquid-vapor mixture of water is contained in a piston-cylinder device at 150 kpa. initially, 1 kg of the water is in the liquid phase and the rest is in the vapor phase. heat is now transferred to the water, and the piston, which is resting on a set of stops, starts moving when the pressure inside reaches 500 kpa. heat transfer continues until the total volume increases by 20 percent. determine (a)-the initial and final temperatures, (b)-the mass of liquid water when the piston first starts moving, and (c)-the work done during this process. d)-show the process on a p-v diagram. you don't need to indicate p& v values, but clearly indicate where all states are located in the phase diagram.

Answers: 3

Answer

You know the right answer?

What are some ways in which power machinery is used in agricultural industry...

Questions