subject
Engineering, 26.02.2020 17:37 sindy35111

While discussing electrical relays: Technician A says that the relay's coil is energized when the circuit's control switch is open. This action connects power to the load circuit. Technician B says that a relay is an electric switch that allows a large amount of current to control a low-current circuit. Who is correct?a. Technician A b. Technician Bc. Both A and Bd. Neither A nor B

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
question
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
question
Engineering, 04.07.2019 18:20
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
You know the right answer?
While discussing electrical relays: Technician A says that the relay's coil is energized when the ci...
Questions
question
Social Studies, 21.06.2019 15:30
question
Chemistry, 21.06.2019 15:30
question
English, 21.06.2019 15:30