subject
Engineering, 26.02.2020 06:02 priscillaoliver4487

Suppose you want to find the sum of two sinusoidal voltages, given as follows: v1(t)=V1 cos(ωt+ϕ1) and v2(t)=V2 cos(ωt+ϕ2)v1(t)=V1 cos(ωt+ϕ1) and v2(t)=V2 cos(ωt+ϕ2).

If you stay in the time domain, you will have to use trigonometric identities to perform the addition. But if you transform to the frequency domain, you can simply add the phasors V1V1 and V2V2 as complex numbers using your calculator. Your answer will be a phasor, so you will need to inverse phasor-transform it to get the answer in the time domain. This is an example of a problem that is easier to solve in the frequency domain than in the time domain.

Use phasor techniques to find an expression for v(t) expressed as a single cosine function, where v(t)=[100cos(300t+45∘)+500cos(300t− 60∘)] V. Enter your expression using the cosine function. Round real numbers using two digits after the decimal point. Any angles used should be in degrees.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
You know the right answer?
Suppose you want to find the sum of two sinusoidal voltages, given as follows: v1(t)=V1 cos(ωt+ϕ1) a...
Questions
question
Mathematics, 23.10.2019 11:00
question
Computers and Technology, 23.10.2019 11:00
question
Mathematics, 23.10.2019 11:00