subject
Engineering, 26.02.2020 03:30 kaytlynnmeyer

Traffic Light Signaling Vehicle-detection sensors are placed along lanes C and D (main road) and lanes A and B (access road). These sensor outputs are low (0) when no vehicle is present and High (1) when a vehicle is present. The intersection traffic light is to be controlled according to the following logic: a) The east-west (E-W) traffic light will be green whenever both lanes C and D are occupied. b) The E-W light will be green whenever either C or D is occupied but lanes A and B are not both occupied. c) The north-south (N-S) light will be green whenever both lanes A and B are occupied but C and D are not both occupied. d) The N-S light will also be green when either A or B is occupied while C and D are both vacant. e) The E-W light will be green when no vehicle is present For the above problem the truth table is constructed having four inputs (A, B,C, D) and two outputs E-W and N-S.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
question
Engineering, 04.07.2019 19:10
Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg.m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?
Answers: 3
question
Engineering, 04.07.2019 19:20
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
You know the right answer?
Traffic Light Signaling Vehicle-detection sensors are placed along lanes C and D (main road) and lan...
Questions
question
Biology, 30.09.2019 16:30