Engineering, 25.02.2020 05:26 bubs9789
"A fluid at a pressure of 7 atm with a specific volume of 0.11 m3/kg is constrained in a cylinder behind a piston. It is allowed to expand under an isothermal process(T = 23 oC) to a pressure of 0.85 atm according to the ideal gas law. a) Calculate the work done by the fluid in the piston. b) Calculate the specific gas constant of the gas. c) calculate the molecular weight of the gas"
Answers: 3
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:20
Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg
Answers: 2
Engineering, 04.07.2019 19:10
Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj
Answers: 2
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
"A fluid at a pressure of 7 atm with a specific volume of 0.11 m3/kg is constrained in a cylinder be...
English, 01.03.2021 01:00
Mathematics, 01.03.2021 01:00
Health, 01.03.2021 01:00
Mathematics, 01.03.2021 01:00
Mathematics, 01.03.2021 01:00
Physics, 01.03.2021 01:00
Physics, 01.03.2021 01:00
Mathematics, 01.03.2021 01:00
Mathematics, 01.03.2021 01:00
Physics, 01.03.2021 01:00
Mathematics, 01.03.2021 01:00
Mathematics, 01.03.2021 01:00