subject
Engineering, 24.02.2020 22:26 sarah8479

NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Two small disks A and B of mass 3 kg and 1.5 kg, respectively, may slide on a horizontal, frictionless surface. They are connected by a cord 600 mm long and spin counterclockwise about their mass center G at the rate of 12 rad/s. At t = 0, the coordinates of G are x0⎯⎯⎯⎯= 0 and y0⎯⎯⎯⎯= 2 m, and its velocity is v0⎯⎯⎯⎯= (1.2 m/s)i +(0.96 m/s)j. Shortly thereafter, the cord breaks; disk A is then observed to move along a path parallel to the y axis and disk B along a path which intersects the x axis at a distance b =7.5 m from O. Determine the distance a from the y axis to the path of A. The distance from the y axis to the path of A is m.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
question
Engineering, 04.07.2019 19:10
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to th...
Questions
question
Mathematics, 28.10.2019 02:31
question
Mathematics, 28.10.2019 02:31
question
English, 28.10.2019 02:31
question
English, 28.10.2019 02:31