Engineering, 21.02.2020 21:31 sophie2001sophie

An aluminum plate 4 mm thick is mounted in a horizontal position, and its bottom surface is well insulated. A special, thin coating is applied to the top surface such that it absorbed 90% of any incident solar radiation, while having an emissivity of 0.20. The density ? and specific heat C of aluminum are known to be 2,700 kg/m3 and 900 J/kg. oK, respectively. Consider conditions for which the plate is at a temperature of 25oC and its top surface is suddenly exposed to ambient air at T? = 20oC and to solar radiation that provides an incident flux of 1,000 W/m2. The convection heat transfer coefficient between the surface and the air is h = 25 W/m2.oK. Stefan-Boltzmann constant: ? = 5.67?10-8 W/m2.oK4.

1) The initial rate of change of the plate temperature is

2) Neglect heat loss by radiation, the steady state temperature of the plate is

3) Include heat loss by radiation, the steady state temperature of the plate is

4) Neglect heat loss by radiation,
the time it takes for the plate to reach 40oC is

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

An aluminum plate 4 mm thick is mounted in a horizontal position, and its bottom surface is well ins...

Questions