Engineering, 21.02.2020 17:19 philliple481
Suppose a student rubs a Teflon rod with wool and then briefly touches it to an initially neutral aluminum rod suspended by insulating threads. What would the net charge on the Teflon rod be? What would the net charge on the aluminum rod be? After the student has touched the aluminum rod with the rubbed Teflon rod, as described above, the student then holds the Teflon rod near the aluminum rod, but does not allow them to touch. The student observes that when the rods are close enough tog
Answers: 2
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
Suppose a student rubs a Teflon rod with wool and then briefly touches it to an initially neutral al...
History, 31.07.2019 20:00
English, 31.07.2019 20:00
Chemistry, 31.07.2019 20:00
Mathematics, 31.07.2019 20:00
Mathematics, 31.07.2019 20:00
Mathematics, 31.07.2019 20:00
English, 31.07.2019 20:00
Mathematics, 31.07.2019 20:00