subject
Engineering, 21.02.2020 06:23 jdto8

The homogeneous, reversible, exothermic, liquid phase reaction: A근R Is being carried out in a reactor system consisting of an ideal PFR followed by an ideal CSTR. The volume of the PFR is 75,000 L, and the volume of the CSTR is 150,000 L. The PFR operates at 150 °C, and the CSTR operates at 125 °C. The volumetric flow rate entering the PFR is 55,000 L/h, the concentration of A in this stream is 6.5 M, and the concentration of R is zero. The reaction is first order in both directions. The rate constant of the forward reaction at 150 °C is 1.28 h and the equilibrium constant based on concertation at 150 °C is 2.5. The rate constant at 125 °C is 0.280 h and the equilibrium constant is 3.51. (a) What is the rate of R leaving the CSTR (mol/h)? (b) The flowrate to the PFR is increased so that the fractional conversion of A is 0.5 in the efluent from the CSTR. All other parameters remain unchanged. What is the new production rate of R?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
You know the right answer?
The homogeneous, reversible, exothermic, liquid phase reaction: A근R Is being carried out in a reacto...
Questions
question
Mathematics, 11.07.2019 14:30
question
Mathematics, 11.07.2019 14:30