subject
Engineering, 21.02.2020 06:10 hudaalkhatib27

7075-T6 Al has a tensile yield strength of σY=450 MPa. A circular tube of 7075-T6 Al supports an axial load of 60 kN in tension and a torque of 1.0 kN-m. The average diameter of the tube is 50.0 mm. Use the von Mises yield criterion.(a)What is the safety factor against yielding if the wall thickness is 2.0 mm? (1.5)(b)What value of thickness with the same diameter would provide a safety factor of 2.0 against yielding? (2.6 mm)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
You know the right answer?
7075-T6 Al has a tensile yield strength of σY=450 MPa. A circular tube of 7075-T6 Al supports an axi...
Questions
question
English, 13.07.2019 02:30