subject
Engineering, 21.02.2020 03:32 terabear2033

After being purged with nitrogen, a low-pressure tank used to store flammable liquids is at a total pressure of 0.03 psig. (a) If the purging process is done in the morning when the tank and its contents are at 55°F, what will be the pressure in the tank when it is at 85℉ in the afternoon? (b) If the maximum design gauge pressure of the tank is 8 inches of water, has the design pressure been exceeded? (c) Speculate on the purpose of purging the tank with nitrogen

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
You know the right answer?
After being purged with nitrogen, a low-pressure tank used to store flammable liquids is at a total...
Questions
question
Physics, 23.04.2021 21:40
question
Mathematics, 23.04.2021 21:40
question
English, 23.04.2021 21:40
question
Spanish, 23.04.2021 21:40