Engineering, 21.02.2020 02:14 rygei2697

An Otto cycle engine is analyzed using the air standard method. Given the conditions at state 1, compression ratio (r), and pressure ratio (rp) for constant volume heat addition, determine the efficiency and other values listed below. The gas constant for air is R = 0.287 KJ/kg-J

a. Determine the specific internal energy (kJ/kg) at state 1.
b. Determine the relative specific volume at state 1.
c. Determine the relative specific volume at state 2.
d. Determine the temperature (K) at state 2.
e. Determine the specific internal energy (kJ/kg) at state 2.
f. Determine the temperature (K) at state 3.
g. Determine the specific internal energy (kJ/kg) at state 3.
h. Determine the relative specific volume at state 3.
i. Determine the relative specific volume at state 4.
j. Determine the temperature (K) at state 4.
k. Determine the specific internal energy (kJ/kg) at state 4.
l. Determine the net work (kJ/kg/cycle) for the engine.
m. Determine the heat addition (kJ/kg/cycle) for the engine.
n. Determine the efficiency (%) of the engine.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

Answer

You know the right answer?

An Otto cycle engine is analyzed using the air standard method. Given the conditions at state 1, com...

Questions