Engineering, 20.02.2020 20:58 luketrup
The rigid bar AD is supported by two steel wires, one of length 15 in and the other of length 8 in, and 1/16-in diameter with a modulus of 29e6 psi and a pin at bracket D. Assume that the wires were initially taut before load P was applied... a. Determine the additional tension in each wire when the 120-1b load P is applied at B b. Determine the deflection at point B C. Discuss why the wires are assumed to be taut (i. e. based on the information provided, what is your rationale for the assumption)
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
You know the right answer?
The rigid bar AD is supported by two steel wires, one of length 15 in and the other of length 8 in,...
Questions
Mathematics, 07.04.2020 17:03
Geography, 07.04.2020 17:03
Mathematics, 07.04.2020 17:03
Mathematics, 07.04.2020 17:03
Social Studies, 07.04.2020 17:03
