Engineering, 20.02.2020 07:07 21tywmeb
A particular op amp using ±15-V supplies operates linearly for outputs in the range−14 V to+14 V. If used in an inverting amplifier configuration of gain −100,what is the rms value of the largest possible sine wave that can be applied at the input without output clipping?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
Engineering, 06.07.2019 03:10
Consider two concentric spheres forming an enclosure with diameters of 12 cm and 18 cm the spheres are maintained at uniform temperatures ti-50°c and t2 = 250°c and have emissivities .45 and .8, respectively. determine the net rate of radiation heat transfer between the two spheres per unit surface area.
Answers: 1
You know the right answer?
A particular op amp using ±15-V supplies operates linearly for outputs in the range−14 V to+14 V. If...
Questions
Computers and Technology, 14.04.2020 23:22
English, 14.04.2020 23:22
English, 14.04.2020 23:22
Mathematics, 14.04.2020 23:22
