Engineering, 19.02.2020 04:56 brillamontijo

A rod of diameter D = 25 mm and thermal conductivity k = 60 W m-1 K-1 protrudes normally from a furnace wall that is at TH. = 220degree C and is covered by insulation of thickness Lins = 200 mm. The rod is welded to the furnace wall and is used as a hanger for supporting instrumentation cables. To avoid damaging the cables, the temperature must be maintained below a specified operating limit of Tmax = 100 degree C. The ambient air temperature is Tinfinity = 23degree C, and the convection coefficient is h = 17 W m-2 K-1. Derive an expression for the exposed surface temperature as a function of axial location on the rod if it is 700 mm long and the tip adiabatic, total and plot the temperature as a function of length. Repeat your calculations for an insulation layer only 100 mm thick.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]

Answers: 3

Answer

You know the right answer?

A rod of diameter D = 25 mm and thermal conductivity k = 60 W m-1 K-1 protrudes normally from a furn...

Questions