Engineering, 18.02.2020 23:56 eve2055

Hot liquid is flowing in a steel pipe with an inner diameter of D, = 22 mm and an outer diameter of D2 = 27 mm. The inner surface of the pipe is coated with a thin fluorinated ethylene propylene (FEP) lining. The thermal conductivity of the pipe wall is 15 W/m. K. The pipe outer surface is subjected to a uniform flux of 1200 W/m2 for a length of 1 m. The hot liquid flowing inside the pipe has a mean temperature of 180°C and a convection heat transfer coefficient of 50 W/m².K. The interface between the FEP lining and the steel surface has a thermal contact conductance of 1500 W/m2.K. a) Determine the temperatures at the lining and at the pipe outer surface for the pipe length subjected to the uniform heat flux. b) What is the total thermal resistance between the two temperatures? c) The ASME Code for Process Piping (ASME B31.3-2014, A323) recommends a maximum temperature for FEP lining to be 204°C. d) Does the FEP lining comply with the recommendation of the code?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is a monomer? how do they form a ploymer from the view point of chemical bonding?

Answers: 1

Answer

You know the right answer?

Hot liquid is flowing in a steel pipe with an inner diameter of D, = 22 mm and an outer diameter of...

Questions