subject
Engineering, 18.02.2020 21:34 jasondesatnick

One challenge for architects is that the design created today will require several years of implementation, verification, and testing before appearing on the market. This means that the architect must project what the technology will be like several years in advance. Sometimes, this is difficult to do.
a: According to the trend in device scaling historically observed by Moore’s law, the number of transistors on a chip in 2028 should be how many times the number in 2018? (You may assume a 40% increase in the number of transistors per year.)
b: The increase in performance once mirrored this trend. Had performance continued to climb at the same rate as in the 1990s, approximately what performance would chips have over the VAX-11/750 in 2028 (assume a 40% increase in performance per year)? You may assume that the speedup in the year 2003 over the VAX-11/750 is 6043x.
c: At the current rate of increase of the mid-2000s (assume 22% per year), what is a more updated projection of performance in 2028? You may assume that the speedup in the year 2010 over the VAX-11/750 is known to be 24,129.
d: What has limited the rate of growth of the clock rate, and what are architects doing with the extra transistors to increase performance?
e: The rate of growth for DRAM capacity has also slowed down. For 20 years, DRAM capacity improved 60% each year. If 8 Gbit DRAM was first available in 2015 and 16 Gbit DRAM was not available until 2019, what is the current DRAM growth rate.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 18:10
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
You know the right answer?
One challenge for architects is that the design created today will require several years of implemen...
Questions
question
Mathematics, 12.12.2020 16:20
question
Advanced Placement (AP), 12.12.2020 16:20
question
Mathematics, 12.12.2020 16:20
question
Medicine, 12.12.2020 16:20
question
Mathematics, 12.12.2020 16:20
question
Mathematics, 12.12.2020 16:20