Engineering, 17.02.2020 21:02 kjhgfcvb5761

Air at 2.5 bar, 400 K is extracted from a main jet enginecompressor for cabin cooling. The extracted air enters a heatexchanger where it is cooled at constant pressure to 325 Kthrough heat transfer with the ambient. It then expandsadiabatically to 1.0 bar through a turbine and is dischargedinto the cabin. The turbine has an isentropic efficiency of80%. If the mass flow rate of the air is 2.0 kg/s, determine(a) the power developed by the turbine, in kW.(b) the rate of heat transfer from the air to the ambient, in kW.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

You know the right answer?

Air at 2.5 bar, 400 K is extracted from a main jet enginecompressor for cabin cooling. The extracted...

Questions