subject
Engineering, 17.02.2020 18:17 Jorjalilli8786

Consider the internal structure of the pseudo-CPU augmented with a single-port register file (i. e., only one register value can be read at a time) containing 32 8-bit registers (R31-R0) and a carry bit (C-bit), which is set/reset after each arithmetic operation. Suppose the pseudo-CPU can be used to implement the AVR instruction ADIW ZH:ZL,32 (Add immediate to word). ADIW is a 16-bit instruction, where the upper byte represents the opcode and the lower byte represents an immediate value, i. e., "32" (do not worry about the fact that the actual format is slightly different). Give the sequence of microoperations required to Fetch and Execute the ADIW instruction.

Your solutions should result in exactly 5 cycles for the fetch cycle and 6 cycles for the execute cycle. Assume the memory is organized into addressable bytes (i. e., each memory word is a byte), MDR, IR, and AC registers are 8-bit wide, and PC and MAR registers are 16-bit wide. Also, assume Internal Data Bus is 16-bit wide and thus can handle 8-bit or 16-bit (as well as portion of 8-bit or 16-bit) transfers in one microoperation and only PC and AC have the capability to increment itself.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
Consider the internal structure of the pseudo-CPU augmented with a single-port register file (i. e.,...
Questions
question
Mathematics, 03.05.2020 14:11
question
Social Studies, 03.05.2020 14:11
question
Mathematics, 03.05.2020 14:11
question
Mathematics, 03.05.2020 14:11