Engineering, 15.02.2020 05:25 summerhumphries3

Objectives: This exercise aims to get you started with the Assembly language. You will get the experience of defining variables, using the Irvine library procedures for I/O and perform some basic integer arithmetic. Description: Write a MASM program to perform the following tasks: 1. Display your name and program title on the screen. 2. Display instructions to the user 3. Prompt the user to enter two (2) numbers 4. Calculate the sum, difference, product, integer quotient and remainder of the numbers. 5. Display the results 6. Say goodbye Requirements: 1. The main procedure must be divided into the following sections: a. Introduction b. Get the data c. Calculate the required values d. Display the results e. Say goodbye Notes: 1. A program template is available on CANVAS 2. You are NOT required to handle negative / floating-point inputs or.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

You know the right answer?

Objectives: This exercise aims to get you started with the Assembly language. You will get the exper...

Questions