subject
Engineering, 13.02.2020 18:40 ashleyacosta

In filter design, it is often possible and convenient to transform a lowpass filter to a highpass filter and vice versa. With H(s) denoting the transfer function of the original filter and G(s) that of the transformed filter, one such commonly used trans-formation consists of replacing s by 1/s; that is, G(s) = H (1/s). For H(s) = .1/(s + 1/2), sketch | H(j omega) |and| g(j omega)|. Determine the linear constant-coefficient differential equation associated with H(s) and with G(s). Now consider a more general case in which H(s) is the transfer function associated with the linear constant-coefficient differential equation in the general form sigma^N _k - 0 a_k d^k y(t)/dt^k = sigma^N _k = 0 b_k d^k x(t)/dt^k. Without any loss of generality, we have assumed that the number of derivatives Nis the same on both sides of the equation, although in any particular case, some of the coefficients may be zero. Determine H(s) and G (s). From your result in part (c), determine, in terms of the coefficients in eq. (P9.63-1), the linear constant coefficient differential equation associated with G(s).

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
You know the right answer?
In filter design, it is often possible and convenient to transform a lowpass filter to a highpass fi...
Questions
question
Mathematics, 06.04.2021 01:50
question
Mathematics, 06.04.2021 01:50
question
Mathematics, 06.04.2021 01:50
question
Mathematics, 06.04.2021 01:50