subject
Engineering, 12.02.2020 03:13 taylorrsmithh

A steam pipe has an outside diameter of 0.12 m. It is insulated with calcium silicate. The insulation is 20 mm thick. The temperature between the outer edge of the pipe and the inner radius of the insulation is maintained at 600 K. Convection and radiation are driving by a temperature of 25 degree C on the outside of the insulation. The convection heat transfer coefficient is 25 W/m^2 -K. The radiation heat transfer coefficient is 30 W/m^2-K. What is the rate of heat loss from the pipe on a per length basis? What is the temperature on the outside surface of the calcium silicate?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
You know the right answer?
A steam pipe has an outside diameter of 0.12 m. It is insulated with calcium silicate. The insulatio...
Questions
question
Social Studies, 09.07.2019 18:30
question
Mathematics, 09.07.2019 18:30
question
Mathematics, 09.07.2019 18:30
question
History, 09.07.2019 18:30