subject
Engineering, 11.02.2020 20:52 vanessacox45

Assuming that the center of gravity is in the center of the bucket directly below the hook block, determine the following about the rigging system and hoist line used to lift a fully loaded concrete bucket.

a) The applied load in each chain

b) The tension in the hoist line

c) The rigging system that is most cost effective. Cost effectiveness is determined by the formula:

Price / Factor of Safety (FoS) where FoS = Rated Capacity/Applied Load

d) The maximum weight that can be lifted without failure of the 3-chain rigging system

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
You know the right answer?
Assuming that the center of gravity is in the center of the bucket directly below the hook block, de...
Questions
question
Mathematics, 19.09.2019 12:00