Engineering, 11.02.2020 01:12 nora45102p45bzz

1)For the circuit below, suppose C=10?f, R1=1000?, R2=3000?, R3=4000?, Is=1mA. The switch closes at t = 0 sec. What is the value of Vc (in volts) just prior to the switch closing? Assume that the switch had been open for a long time. Enter your answer in the box below without units.

2)For the circuit above, what is the value of Vc after the switch has been closed for a long time?

3)What is the time constant of the circuit (in seconds)? Enter the answer below without units.

4)What is the value of Vc at t = 2msec (in volts). Enter the answer in the box below without units.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

1)For the circuit below, suppose C=10?f, R1=1000?, R2=3000?, R3=4000?, Is=1mA. The switch closes at...

Questions